Search results

Rick, Small dings are not a problem. The microBeater does not care. Please PM overall length of pipe and price for pipe/muffler. Thanks, Glenn

That's the one Ray!!! I was wrong about the O.D. it is 1.61" like you said. Please PM a price for both. Thanks, Glenn

40" microburst / .45 power. Appreciate you looking for me Rick. Thanks, Glenn

Looking for new or like new Macs 1160 (10 cc aero pipe) and Rum racing or Prather muffler(.45 size). No junk or cut down pipe. The 1160 is 13 1/8" long and 1.61" diameter at largest part. Thanks, Glenn

Happy Veterans Day to all and thank you for your service. Hope you all have a GREAT day. Glenn Gates

Stu Barr or Al Hobbs on the needle bearings.

Bill Brant has the heavier .67/.80 CMB gaskets.

The T designation following the alloy is very important. Dick uses T-3 on fins as it can be bent. T-6 is not good for bending. If the material alloy is followed by a O it means it is annealed.

Don, I need 1ea. of the .67 size and one each of the .45 size. Please send a pm regarding price. Thanks, Glenn

I'll take the 1455/3 Buck. Glenn Gates

The last NASCAR race I tried to watch was when JPM crashed into the jet dryer and set the track on fire. 2012??

Thank you Phil .

Don, I could use 2 ea. .45 size base and 2 O.S. 40A needles if you have some to go with the bases. Thanks, Glenn

I can use one of the 24"X 3/16 if Phil does not want all 3. Glenn

The newest model has a billet drum housing and there was some problems (insufficient oil clearance in drum valve/ bushing). The previous model(cast drum housing) had no issues and I'm partial to the cast housing-One less problem. All the inners are the same. You got a good motor for a good price.

The newest model has a billet drum housing and there was some problems (insufficient oil clearance in drum valve/ bushing). The previous model(cast drum housing) had no issues and I'm partial to the cast housing-One less problem. All the inners are the same. You got a good motor for a good price.

You can make bottom mounts or have Mike Hughes make some for you.

You can get all the hardware from Lenny Blake (rum racing). All of the hulls I've seen develop cracks starting at the square corners of the hull opening. Grinding a 1/8" radius in the sharp corners should prevent that.

Karl. I sent Tony a birthday card on the 17th, called him on his birthday and his birthday card arrived back here on the 26th stamped Moved-left no address :lol:

I;ll take it Shane Glenn