Terry Keeley
Well-Known Member
- Joined
- Jul 24, 2002
- Messages
- 7,202
A little update, I've trimmed the wheel to 5" and am getting run times where I want them. Having some issues with vibration on the oiler at the coupler but I've isolated it now and will try it tomorrow.
I recently got the EngMod2T software and am digging into it, it's very detailed and will take some time to get ports mapped out and other data entered. Once done I'll run a simulation on this stock CMB 67 and compare it to the dyno, there are tweaks that can be done to match the two then it's supposed to be very good at simulating changes. I'll use it to design pipes etc. then try them on the dyno and finally in a boat.
At least that's the the plan.
I recently got the EngMod2T software and am digging into it, it's very detailed and will take some time to get ports mapped out and other data entered. Once done I'll run a simulation on this stock CMB 67 and compare it to the dyno, there are tweaks that can be done to match the two then it's supposed to be very good at simulating changes. I'll use it to design pipes etc. then try them on the dyno and finally in a boat.
At least that's the the plan.
Last edited:
