Search results

I use the airlab app for prop/pipe/tuning decisions, but your best freind for proper nitro tuning is having and knowing how to use a remote mixture control. Launch rich and tune in the mill. I prefer the fuel doctor barrel valve style over the needle style. My flow meter is only used for initial...

Throw that bracket away and make two from angle stock. Spread the load out.

The ML kits are based on drawings from Newton, which are 1/8 scale drawings for the most part. There are no build instructions and they require a good knowledge of scale hydro construction. The rc unlimiteds web site has some older videos along with Scot's videos that will help.

They are easy, though a bit time consuming the first time, to make if you have access lathe.

Follow what Mike and Alex have said. Run a hot plug. 1L was always my favorite, and be gentle during the brake in. We use 66% with 17% oil

If the base isn't fuel proof. Everything will be fine until you get a scratch in the clear. Usually happens somewhere in the engine compartment. Then the whole paint job lifts.

Is that paint fuel proof on its own?

Phil, By my interpretation, your stand would be acceptable.

Nope. Properly shrouded from the sides and rear to protect from accidental contact. The prop guard must be made of structurally rigid material.

It was actually designed to tilt the engine back lifting the nose when turned. Way back when, I fitted one to a boat. Made an evil boat worse. We also ran turn fins back then on most tunnels.

I believe they are required in Europe. If done correctly it should not hinder performance.

Velcro to the lid so antenna can get as far out as possible.

This is the first wide body boat. Another wide body is ready to go to the east coast, and a standard boat to another local. The prototype nitro boat is almost done. Been busy in the boat shop. These boats take me a ton of time to build.

That's Amazing. Congratulations Chris!

Mike Call me. I should have one.

RC Boatworks Y-21

Exhaust temp would be better if you are trying to use the data to tune with. Cylinder head if you want to be able to see if a water line comes off etc.

Our twin is not the normal 10" tub. Cowl probably won't fit anything else out there.

I just got a tank from Walt. If Bruce bought the business, He will continue the great work that Walt has always done.

Welcome. Looks like there is some racing 3 hours from you. Hav you hit up NAMBA District 20 to see if there are other boater close? Rookieboater on here is an active member in Colorado.