Search results

Thank you Dick!! See you there buddy.

Greeting, The 2024 IMPBA 25th Anniversary Gas Nationals has SOLD OUT with +80 contestants and close to 300 boats! The District 13 Racers Group are currently seeking trophy and raffle sponsors for this epic event. Class sponsorships are $175.00 each and we are accepting all reasonable raffle...

Thanks to the Atlanta Model Boaters for sponsoring LSG 36 Mono & Thanks to HUFFRACING for the donation of (2) Gift certificates for $100 off any HR Modified Engine

Got a box of good stuff from Futaba USA today, Thank you GUYS!! · 4PM Plus Transmitter from Futaba USA · S9373SV Servo from Futaba USA · 2100mAh LiFe TX Battery from Futaba USA

Hello Racers, Please check your email for a message from district13racersgroup(at)gmail(dot)com requesting your t-shirt size. We need this info ASAP so we can get the order in. Here are the people we still need to hear from: Hello Racers, Please check your email for a message from...

Aaron, I'll take: Nova46 12mm used $75us

Thank you Voodoo Model Boat Club, Bob at The Propworks, and Raul at Rodriguez Custom Race Works! Greeting, The 2024 IMPBA 25th Anniversary Gas Nationals has SOLD OUT with +80 contestants and close to 300 boats! The District 13 Racers Group are currently seeking trophy and raffle sponsors for...

Greeting, The 2024 IMPBA 25th Anniversary Gas Nationals has SOLD OUT with +80 contestants and close to 300 boats! The District 13 Racers Group are currently seeking trophy and raffle sponsors for this epic event. Class sponsorships are $175.00 each and we are accepting all reasonable raffle...

If this is still available, I will take it.

StumpFab is what I used. https://stumpfabrication.com/collections/outrigger-hydro-parts/products/universal-21-45-delrin-motor-mount-system

It has been an amazing response so far for the 2024 IMPBA Gas Nationals. To date we have 85 racers and 284 boats entered and with guests we have 102 that will be attending the banquet on Friday night. There are a (5) classes that are SOLD OUT, with a few that are close to sell out. The deadline...

MM......AAIGHT DEN

Can be Y or T shaped. Thread hole with bottoming tap. Cap head machine screw long enough to bottom out/block flow. Tubing over the cap head screw to hold screw in position and to seal.

Al, How much does (10,000) 1.5mm x 7.8mm chrome steel needle bearings weigh?

15cc should be around 11.5”-11.75”. Make the hole the same size as the ID of the brass fitting. Regulate flow at rudder.

Yes, but do not get any in your water or fuel tubing, it will make them soft and deteriorate. I like to use it only when the engine is out of the boat and being stored. In between days at a race a run WD-40 through the engine and then flood with Marvel Mystery Oil.

I feel like I could have left them in, motor ran great before I took them out.