Recent content by Roxyflash

Looking fast just sitting there the decals sure make it complete

Looks like it’s beefed up on the build.The paint is turning out real nice!Looks fast just sitting there!

All you need is a zipkitts pipe great job!I leave the stuffing tube shaft exit out of transom open to self bail water out of the hull.

Received the flex shaft borrowed a Boris flow gauge from Adam set it to 48 test fired the engine.I have never ran anything bigger then 67 size nitro wise.Wasnt sure what I was thinking this thing is a beast it’s loud and proud!Im going to put a muffler on it hopefully try it out Saturday...

Need one for a transmitter seeing if anyone had one laying around.

Thanks Mike got the cowl painted should have went another round of filling the pins holes but ran out of primer didn’t want to buy more so I painted it.Waiting on flex shaft to show up other wise it’s done.

With help from Mark I was able to get a header it was 18 degree so I had to bend it turned out good.The pipe was same diameter as the header pipe so I used my wirsbo expander.Got the cowl primered next I need to paint it.Wheres the best place to buy the header spring?

I just sent out the rudders and servo if I would of known you were interested I would have threw it in for free it’s only good for parts

The orange layed down nice.Looks good a little orange peal don’t hurt some new cars have that effect.

Sent you a pm

Took this on trade for ready to run gas mono fun boat.Had a water blast pickup and giant scale servo.Put a regular water pick up rudder on it.I didn’t like the linkage on the giant scale servo so I put a standard size servo with straight tig rod linkage.The boat had a Teflon liner for flex shaft...

Not sure what brand these rudders are there’s no water pickup on them.S3303 giant servo tested works 40 shipped

Are you going to clear over it with some ureathane?

Looks good what paint you use?

Need one for a rigger